Customization: | Available |
---|---|
Frequency Range: | 300-700MHz |
Frequency: | 300-700MHz |
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
Parameter | Specification | Remark |
Frequency | 1550~1620MHz | |
Signal Bandwidth | 70MHz | VCO |
Saturated Output Power | 50±1dB | |
Large Signal Gain | 50±1dB | |
Gain Flatness | ≤2.0dB | |
Gain Stability | ±1.5dBm | at -25ºC~+55ºC |
Power stability | ±1.5dBm | at -25ºC~+55ºC |
Output VSWR | ≤1.5 | |
DC Input Voltage | DC28±1.0V | |
Current Consumption | 10.5A typ; 12.5A max. |
@ Pout=100W CW, 50 ohms load |
Working Temperature | -25~+55ºC | |
Monitoring interface | 7W2 Connector: A1: GND; A2: +28V; PIN1: RS485A; PIN2: RS485B; PIN3: GND; PIN4: NC; PIN5: Power amplifier enable switch,High level +5V off, low level 0V on. |
|
LTD pilot lamp | POWER:Power Supply pilot lamp; RUN:Run pilot lamp; ALARM:Fault alarm pilot lamp. |
|
Monitoring type | RS485,Baud rate 19200 | |
Monitoring function | 1. Power amplifier query:module status (including power amplifier status, over temperature alarm, standing wave ratio alarm, power amplifier fault alarm); 2. Power amplifier enable switch: Turn on or off the power amplifier. 3. Over temperature alarm: The temperature threshold is +85ºC. If the detected temperature exceeds +85ºC, an alarm will be triggered, and the power amplifier will be turned off. When it reaches +65ºC, the power amplifier will be turned on; 4. Power amplifier standing wave alarm:When the power amplifier standing wave detection is greater than 4.0, the power amplifier starts protection; 5. Overvoltage alarm of power amplifier:When the power amplifier voltage exceeds 32V, the power amplifier will automatically shut down; 6. Power amplifier undervoltage alarm: When the power amplifier voltage is below 24V, the power amplifier will automatically shut down |
|
RF output connector | N-K | |
Dimension | 170×79.5×24mm | |
Installation Dimension | 164×73.5×24mm | |
Screw Size | 4-Ø3.2mm | |