Customization: | Available |
---|---|
Type: | Wideband |
Selling Units: | Single Item |
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
Parameter
|
Specification
|
Remark
|
Frequency
|
24002600MHz
|
|
Output Power(dBm)
|
100W(50dBm)
|
VCO
|
Signal Bandwidth
|
100MHz
|
|
Saturated Output Power
|
50±1dB
|
|
Large Signal Gain
|
50±1dB
|
|
Gain Flatness
|
≤2.0dB
|
|
Gain Stability
|
±1.5dBm
|
at -25+55
|
Power stability
|
±1.5dBm
|
at -25+55
|
Output VSWR
|
≤1.5
|
|
DC Input Voltage
|
DC28±1.0V
|
|
Current Consumption
|
10.5A typ;
12.5A max. |
@ Pout=100W CW,
50 ohms load |
Working Temperature
|
-25+55
|
|
Monitoring interface
|
7W2 Connector:
A1: GND; A2: +28V; PIN1: RS485A; PIN2: RS485B; PIN3: GND; PIN4: NC; PIN5: Power amplifier enable switch,High level +5V off, low level 0V on. |
|
LTD pilot lamp
|
POWERPower Supply pilot lamp
RUNRun pilot lamp ALARMFault alarm pilot lamp. |
|
Monitoring type
|
RS485Baud rate 19200
|
|
Monitoring function
|
1. Power amplifier query:module status (including power
amplifier status, over temperature alarm, standing wave ratio alarm, power amplifier fault alarm); 2. Power amplifier enable switch: Turn on or off the power amplifier. 3. Over temperature alarm: The temperature threshold is +85. If the detected temperature exceeds +85, an alarm will be triggered, and the power amplifier will be turned off. When it reaches +65, the power amplifier will be turned on; 4. Power amplifier standing wave alarm:When the power amplifier standing wave detection is greater than 4.0, the power amplifier starts protection; 5. Overvoltage alarm of power amplifier:When the power amplifier voltage exceeds 32V, the power amplifier will automatically shut down; 6. Power amplifier undervoltage alarm: When the power amplifier voltage is below 24V, the power amplifier will automatically shut down |
|
RF output connector
|
N-K
|
|
Dimension
|
170×79.5×24mm
|
|
Installation Dimension
|
164×73.5×24mm
|
|
Screw Size
|
4-Ø3.2mm
|
|